Maximum Resiliency Means Minimal Maintenance
Endura cabinetry is built to be UV and weather resistant.
Crafted from high-density polyethylene (HDPE), Endura
is built to withstand rigorous daily outdoor and indoor
use. To keep Endura cabinetry looking good, follow these
simple cleaning instructions
General Care
• Clean regularly with a standard soap and water
solution and a soft cotton cloth.
• Acceptable cleaners: 10% chlorine bleach dilution,
hand washing liquid soap, glass cleaner, ammonia,
furniture polish.
• If debris or grease appears on the surface, spray the
affected area with a garden hose. If necessary, remove
excess dirt and debris by scrubbing with a soft bristle
brush or sponge.
• Allow the material to air dry or use a soft towel to
remove excess moisture.
• A pressure washer with no greater than 1500 PSI
may be used to remove dirt, dust, or other types of
airborne particulates. Use a wide angled (40º >) spray
nozzle and do not direct the sprayer less than 8” from
the cabinetry surface.
AVOID The Following Cleaning Products
• Chemical cleaners, sprays, and hard scrubbers.
• Spic & Span which contains abrasives Sodium
Carbonate and Sodium Silicate.
• Tilex which contains Sodium Hypochlorite.
• Comet which contains abrasives Calcium Carbonate
and Sodium Carbonate.
Hardware Cleaning Care
Decorative surface hardware such as drawer and
door pulls, and knobs should be stainless steel, with
stainless steel screws for best results. Refer to the
hardware manufacturer’s recommendations for the
cleaning of stainless steel hardware.
Hinges require little to no maintenance. Should dust or
debris appears on the surface of a hinge, remove using
a soft bristle brush or toothbrush.
Apply spray lubricant such as WD-40 to the hinge. Then
open and close the cabinet door a few times so the lubricant
can work into the hinge while its parts are in motion.
CAUTION: Storing open containers of caustic chemicals
inside the cabinets can be corrosive to the hinges.